back

Bonded waterproof membrane on balconies and terraces – AQUAFIN-TBS, normal setting

The selection of a suitable system is very important for the sound installation of stone and ceramic on balconies and terraces. Due to different expansion of the materials used, stresses occur in the build-up of the layers, due to the temperature changes experienced. These must be permanently compensated for so that there is no break within the build-up of the layers. Furthermore, dependent on the temperature exposure, the length of edges in the tiled bays should be restricted from 2 – 5 m. The aspect ratio of the tiled bays should be as squat as possible from up to 1:2.

Print page
PRIMING

Solvent free universal primer, water and alkali resistant

LEVELLING

Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm

Water repellent, rapid hardening screed mortar with high strength bonded with ASOCRET-HB-flex

WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

Waterproof tape for bridging bay edge joints and connections

TILE INSTALLATION

Highly deformable flexible adhesive for heavy duty areas

GROUTING

Cement-based, water impermeable grout with improved mechanical and chemical resistance for joint widths from 3 – 20 mm

Rapid hardening flexible grout, 3 – 20 mm joint width

Silicone sealant for movement joints

Silicone sealant for use with natural stone