Installation on old tiled finishes

The existing tiled finish must be sound and load bearing. Remove loose areas and repair with MGIII cement mortar. The substrate must be cleaned and all adhesion inhibiting components such as e.g. lime, grease, dirt etc must be removed. Resin repair cracks in the substrate with a reaction resin. Abrading the old tiling increases the bond of the primer or scratch coat.

Print page

PRIMING

	Rapid drying, quartz filled dispersion primer for absorbent and non-absorbent substrates	ASO-Unigrund-S
	Flexible mineral-based waterproof slurry as a scratch coat	AQUAFIN-RS300

WATERPROOFING

	Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas	AQUAFIN-RS300 AQUAFIN-2K/M-PLUS
	One component flexible waterproof slurry, wall/floor	AQUAFIN-1K-PREMIUM
	Fabric reinforced sheet style bonded waterproof membrane	SANIFIN

TILE INSTALLATION

	Grey, highly flexible adhesive for interior and exterior use	MONOFLEX-XL
	Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use	SOLOFLEX-fast

GROUTING

	Simple to use grout, up to 6 mm joint widths	CRISTALLFUGE
	Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1-10 mm joint widths with FAST TECHNOLOGY	CRISTALLFUGE-PLUS
	Silicone sealant for movement joints	ESCOSIL-2000
	Silicone sealant for discolouration-free elastic jointing	ESCOSIL-2000-ST