back

Installation on render (mortar group PII and PIII to DIN 18550)

All cement-based renders beneath ceramic tiles or natural stone are to be struck off tightly with a straight edge. The surface must remain rough and may not be smoothened or felt boarded. To enable an orderly tile installation, increased requirements for flatness of the render should be stipulated.

Print page
PRIMING

Solvent free universal primer, water and alkali resistant

LEVELLING

Non-sag, cement-based, rapid hardening, polymer modified, low shrinkage and creamy smoothing compound, 2 – 50 mm

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

WATERPROOFING

Flexible, mineral-based, vapour permeable waterproof slurry for areas with increased demands in interior and exterior areas

One component flexible waterproof slurry, wall/floor

Fabric reinforced sheet style bonded waterproof membrane

TILE INSTALLATION

Lightweight, low dust flexible adhesive for thin, medium and thick bed installation techniques

Rapid hardening, highly slump resistant flexible adhesive for interior and exterior use

Flexible adhesive mortar with good slump resistance

Flexible natural stone adhesive

GROUTING

Simple to use grout, up to 6 mm joint widths

Mineral-based multi-function flexible grout for tiles, natural stone and other finishes from 1 to 10 mm joint widths, with FAST TECHNOLOGY

Silicone sealant for movement joints

Silicone sealant for discolouration-free elastic jointing